 2.svg){kind=small}
Bluetooth meter and data logger for pH and temperature in soil
€89,90
This digital soil tester can measure temperature and pH (acidic or alkaline) in soils and other substrates.
Moreover, the meter has a unique design with a stainless steel protective cap. This makes it possible to measure in hard soil, sandy soil and other substrates. There is a wide range of applications: gardening, lawn, vegetable garden, agriculture, and cultivation in greenhouses. Indoor and outdoor use.
Installation
Make sure bluetooth is activated on the phone and install the APP Yinmik on the phone. Open the APP. Now connect the meter via Bluetooth to the APP Yinmik by pressing the ‘ON/OFF’ button for 3-5 seconds. The Bluetooth symbol will appear in the display. The meter will automatically connect to the APP and the model of the meter will appear at the top of the APP’s screen (BLE – YY1033).
Measurement
To start measuring, first remove the plastic protective cap from the tip by twisting off the cap. Now place the stainless steel protective cap over the tip of the probe. Do not forget otherwise the electronic probe will be damaged ! Now press the probe vertically into the soil and make sure the soil is well moistened. The measurement results quickly appear on the LCD screen and in the APP. You can set a minimum value and a maximum value in advance. As soon as these are exceeded, the measurement result in the APP turns red. After use, rinse the tip well with distilled water and then dry it with a soft cloth. Replace the plastic protective cap.
Bluetooth meter and data logger for soil pH and temperature
- The meter has a probe (length 13 cm) with the latest technology.
- The use of a stainless steel protective cap allows measurement even in hard soil.
- Should the probe break down, it is available separately. In addition, the meter has a backlit LCD display. All data can be read, stored, exported, shared and printed via bluetooth using the APP Yinmik.
- Because of its hefty memory (1000 data records), the meter is also usable as a data logger and suitable for storing a lot of long-term data.
- The maximum deviation is 0.1 pH within the range 0.00 pH -14.0 pH. Equipped with automatic temperature compensation as standard.
- You need 4 LR44 batteries (included).
- Thanks to accurate and real-time Bluetooth data transmission, you can easily store, manage and share test data.
How do you adjust soil pH?
A pH of around 6.5 is suitable for almost all gardens, as most plants grow in a range of pH 6.0 to pH 7.0 (slightly acidic to neutral). Once you have determined the soil pH, use a special soil conditioner to adjust the soil pH to the plant’s ideal pH range.
Calibration
Calibration is very easy and quick to perform. Prepare 3 cups with 25 cl of distilled water. Then dissolve 3 different bags of buffer powder (7.00, 4.00 and 10.01) in the 3 cups. Place the tip of the measuring pen in buffer solution 7.00 Now wait until the measurement result changes little or nothing and then press the ‘CAL’ button for 5 sec. ‘CAL’ will also appear in the display. Now release the button and wait until the value 7.0 flashes three times in the display. Repeat this procedure in the cup with buffer solution 4.00 (at the end, the value 4.0 flashes three times in the display) and perform the same procedure again in buffer solution 10.01 (at the end, the value 10.00 flashes 3 times in the display). All calibration data are automatically stored and saved.
Be the first to review “Bluetooth meter and data logger for pH and temperature in soil”
Reviews
There are no reviews yet.